Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Fullerton, CA
Gate installation in Fullerton usually means replacing a wood driveway gate that has racked out of square on posts set decades ago in expansive clay soil, or adding an electric opener to a gate that was never framed for one. San Diego Gate Company has served Fullerton since 2018, and we see the same pattern across the 92832, 92833, 92834, and 92835 ZIP codes: post movement from the wet-dry seasonal swing, wood frames that have shrunk and split, and hinges that are no longer doing their job. Call (877) 517-5469 and we’ll send a gate specialist, not a general contractor, to assess your gate, your posts, and the ground they’re set in.
Why Fullerton Homes Are Different
Fullerton’s housing stock runs from 1920s Craftsman bungalows near downtown and the colleges to 1960s and 70s tract homes in the 92833 and 92835 areas. The older neighborhoods are full of driveway and side-yard gates hung on 4×4 posts set directly into clay soil, often without any concrete footing. After a wet winter, that clay heaves. After a dry Santa Ana stretch, it shrinks back. The result is a gate that drags on the pavement, a latch that no longer lines up, and hardware that wears fast because it’s fighting the geometry every time the gate opens and closes. Wood gates in this climate also split along the grain during the dry months, which means a hinge or latch pull can tear right out of the frame. When we work in Fullerton, we are usually resetting posts and re-hanging the gate, not just swapping hinges. That is the honest diagnosis most homes here need.
Styles & brands we work with
Our Main Fullerton Services
Most Fullerton calls to us fall into two categories: a gate that won’t swing or latch properly, and an electric gate that has stopped responding to a remote, keypad, or safety sensor. Here is what each one looks like in Fullerton specifically.
Gate Repair in Fullerton
Fullerton gate repair is rarely a simple hardware swap. The clay soil under pre-war and mid-century homes moves with the seasons, which means the post has usually shifted and the gate has dropped out of alignment. We reset posts in concrete where needed, re-square the gate frame, replace rotted wood sections, and install hardware that is sized for the actual weight of the gate. Redwood and cedar driveway gates here are often heavier than they look after decades of weather exposure. Gate Repair in Fullerton gets into what this costs and how we diagnose the real problem.
Electric Gate Repair in Fullerton
Electric gate operators in Fullerton work hard. The same post movement that racks a manual gate also stresses an opener’s arm, track, or hinge bracket until something bends or fails. We see burned-out motors on gates that were binding, damaged safety loops on driveway gates, and keypads that work intermittently after a rain cycle. Our technicians are trained on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Electric Gate Repair in Fullerton covers the diagnostics and pricing in detail.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Fullerton
Gate installation in Fullerton is a different job than in coastal towns. The combination of expansive clay soil, hot dry summers, and older housing stock with undersized posts means a new gate has to be built and set to last, not just bolted onto whatever is already there. We install automatic gates, driveway gates, sliding gates, and pedestrian gates sized for the opening, the terrain, and the way your property actually drains. For a complete look at what we build, see Gate Installation.
Automatic Gate Installation
Signs you need it
You are getting out of the car in the rain, or at night, to open a gate that should respond to a remote.
What it costs in Fullerton
Automatic gate installation in Fullerton typically runs $2,800 – $6,600 for a single swing gate with operator, depending on gate size, post condition, and electrical access.
How we do it
We check post strength first, then install or replace the gate frame, mount the operator, run power, and set travel limits and safety sensors.
Driveway Gate Installation
Signs you need it
Your existing driveway gate is sagging, splitting, dragging, or no longer closes the opening securely.
What it costs in Fullerton
A new driveway gate in Fullerton typically costs $2,300 – $5,100 installed, with the final number driven by width, material, and whether the posts need to be reset or poured new.
How we do it
We remove the old gate, pour or repair post footings, build or install the new gate to the opening, and set the hinges and latch so it moves cleanly for years.
Sliding Gate Installation
Signs you need it
Your driveway slopes, or the opening is wide enough that a swing gate would cover too much of the approach.
What it costs in Fullerton
Sliding gate installation in Fullerton typically runs $3,400 – $7,800, with the range set by gate length, track or cantilever hardware, and operator choice.
How we do it
We set the track or cantilever posts, mount the gate frame, hang and level the gate, then install the operator and safety loops if it is automated.
What Gate Installation Costs in Fullerton
| Item | Typical range in Fullerton |
|---|---|
| Manual driveway gate installed | $1,450 – $3,800 |
| Electric driveway gate with operator | $2,800 – $6,600 |
| Sliding gate with operator | $3,400 – $7,800 |
Do I need a permit to install a gate in Fullerton?
Most residential gate replacements on existing posts do not need a permit in Fullerton. New footings, electrical runs for an operator, or anything taller than the city’s height limit may trigger plan review, and we can check that before work begins.
How long does a Fullerton gate installation take?
A typical single driveway gate with new posts takes one day for the gate and posts, plus a second visit if the operator needs an electrician’s connection. We give you that schedule before work starts.
Brands We Service in Fullerton
Our technicians carry parts and controls for FAAC, BFT, Linear, and Viking, among the nine major brands we service. In Fullerton, that means we can often repair an operator the same visit rather than ordering a part and coming back. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Fullerton, CA
| Service | Typical range in Fullerton |
|---|---|
| Gate repair service call | $85 – $145 |
| Gate hinge replacement | $180 – $410 |
| Gate post reset | $410 – $950 |
| Manual driveway gate installed | $1,450 – $3,800 |
| Electric driveway gate with operator | $2,800 – $6,600 |
| Sliding gate with operator | $3,400 – $7,800 |
| Electric gate repair | $210 – $610 |
| Operator replacement | $720 – $1,880 |
| Safety loop repair | $320 – $780 |
In Fullerton, prices push toward the higher end when posts have to be dug out of clay and poured with new concrete, or when a wood gate’s frame has split and needs to be rebuilt rather than re-hung. Whatever the number is, you get it in writing before any work begins, and that is the number you pay.
Neighborhoods We Serve in Fullerton
We work throughout Fullerton in the older downtown-adjacent blocks, the college-area neighborhoods, and the 1960s and 70s tract subdivisions further out. Most repair calls get a same-week visit, and emergencies where a gate is stuck open or blocking a driveway get priority.
- Downtown Fullerton and the old central blocks
- Neighborhoods near Cal State Fullerton and Fullerton College
- The 92833 subdivisions south of Orangethorpe
- The 92835 hillside streets above Bastanchury
- The 92832 pocket west of Harbor
Service Area – Cities Near Fullerton
We also cover the surrounding North Orange County cities for gate repair, electric gate repair, and installation. If you are in Anaheim, CA, La Habra, CA, Placentia, CA, or Brea, CA, call the same number and we will schedule you the same way we schedule Fullerton jobs.
Serving Fullerton, CA — Our Local Coverage Area
We’re based in the Fullerton area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Fullerton
Most Fullerton repair calls are scheduled within a few business days. Gates that are stuck open, dragging dangerously, or leaving a property unsecured get priority, and we will tell you on the call when we can be there.
Some Fullerton HOAs do have architectural guidelines for driveway gates, particularly in planned communities in the 92833 and 92835 areas. If your HOA needs a specific material, height, or finish, bring that to the estimate and we will match it.
Yes. Sloped driveways in Fullerton often call for a sliding gate or a swing gate with a properly spaced bottom gap, and we account for the grade so the gate does not bind at the low end. Call (877) 517-5469 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fullerton Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
— Alejandro Mendoza"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Rosa Delgado"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Carrie Hoffman